- Alnico II Premium Blah Pickups
- Jack Plate and Jack
- Neck Plate (and screws)
The last one is important because the current one says Squier on it. I'm wondering if the GFS one really will be heavier and whether that means anything. At the very least though, this removes the last observable vestige of Squierdom on the guitar.
I'll be trying out blender wiring, and I'm doing some research - found some interesting information on this thread.
Someone on that thread also mentioned star grounding, so I hastened to Radio Shack and bought some Star Ring Terminals. At worst, it will keep things neater. I really should have bought some copper to shield the body while I was at it. Bleh. Anyhow ... I'll solder the 3 pickup groups plus the ground from the volume pot, plus the claw ground to this thing, then run a wire from it to the jack ground. Once I do the copper thing, I can screw the terminal into the copper and I'll be done.
Someone on that thread also mentioned star grounding, so I hastened to Radio Shack and bought some Star Ring Terminals. At worst, it will keep things neater. I really should have bought some copper to shield the body while I was at it. Bleh. Anyhow ... I'll solder the 3 pickup groups plus the ground from the volume pot, plus the claw ground to this thing, then run a wire from it to the jack ground. Once I do the copper thing, I can screw the terminal into the copper and I'll be done.
No comments:
Post a Comment